Apr 29, 2005 · From a Windows workstation that connects to the Linksys, I can ping the LAN IP of the linux box at IP 10.0.0.2, as well as the WAN IP of the linux box at IP 192.168.7.2. However, I cannot ping the LAN (inside interface) of the GNET router/modem at IP 192.168.7.1. However, like I said before from the Linux box no problem : linux:~ # ping 192.168.7.1

Nov 08, 2006 Making your Linux Box Into a Router – DataBook® for Linux Making your Linux Box Into a Router. Up one level: Network Configuration. Previous: Introduction to Network Routing. Next: Configuring Network Interface Controllers (NIC) Three things are required to make a Linux box into a router. From a hardware standpoint you need two NICs. Each NIC must be connected to a different network segment. How to Make a CentOS 7 Router – Linux Hint The router will act as a DHCP server and forward IP packets to the private network. I will configure the DHCP pool in the range 192.168.50.50/24 to 192.168.50.100/24 . This is how I am going to configure the CentOS 7 router in this article.

Green lines (work PC - Linux box - router) My logic is that I can easily wireshark the e4 + e5 portion and not be cluttered with any other fluff from the regular working of the Linux box. I was thinking that e4 could pretend to be my router (so work PC sees the expected router) and similarly e5 could pretend to be the work PC (so router sees

Raspberry Pi as a home router - Vladimír Záhradník Therefore, I decided to migrate to OpenWrt, which is an open-source Linux distribution aimed at routers. Due to this, many features were just there, including OpenVPN on UDP, and proper DSLite support. OpenWrt had many software packages available out of the box.

Router is an expensive device. Configuring it is also a complex task. Not every network, especially the small and home office network, can afford it. Linux provides a zero-cost solution for the IP forwarding. If you have a Linux system in your network, you can use it for the IP forwarding.

Dec 22, 2010 Linux as a router. - Ars Technica OpenForum Jan 02, 2016 HowTo: Software Routers on Virtual Machines - Dowd and (for pfSense, uncheck the “cable connected” box) for adapter 2’s tab, select the NIC that is connected to the rest of your network (switch, wireless access point, hub, another router’s switch ports - not the WAN port!) - and select “PC-NET FAST III” as the adapter type: (pfSense: uncheck “Cable Connected” box.)